The DSSM is an ultra-compact, fully digital, IP57-rated transmitter built for theatre, TV/film and broadcast. It delivers high-density (HDM) mode for maximum channel counts in tight spectrum, D2 compatibility with selectable RF power (50/25/10 mW) plus 4 mW HDM, and AES-256 encryption for secure links. A wide UHF tuning range provides over 6000 frequencies, while the IR port speeds setup, and USB/Wireless Designer supports firmware updates.
The servo-bias input handles mic/line/instrument with a wide 1 dB-step gain range and a dual-envelope limiter that tolerates 30 dB above full modulation for clean peaks. The locking 3-pin sub-mini input, OLED interface, and dock-charge capability (optional CHSDSSM) make it fast and robust on set. The machined aluminium housing uses a conductive, super-hard ebENi finish; a repositionable wire belt clip is included.
FEATURES
- IP57 water- and dust-resistant design for demanding environments
- HDM high-density mode for max channel counts in limited spectrum
- Selectable RF power: 50/25/10 mW (D2), 4 mW (HDM)
- Over 6000 frequencies across a wide UHF range with 25 kHz steps
- AES-256-CTR encryption for secure transmission
- Wide input gain in 1 dB steps with dual-envelope soft limiter
- Two-way IR for quick setup; USB/Wireless Designer firmware updates
- Dock-chargeable via optional CHSDSSM; LB-50 Li-ion battery
- OLED interface, membrane switches, and bi-colour LEDs for status
- Machined aluminium body with ebENi finish; repositionable belt clip
WHAT’S IN THE BOX:
1 x AMM22 – Whip antenna with Standard SMA Connector
1 x AMM25 – Whip antenna with Standard SMA Connector
1 x Pouch
1 x Lithium Battery
1 x Wire Belt Clip
SPECIFICATIONS
| Operating Frequencies | DSSM-A1B1: 470.100 to 607.950 DSSM/E01-A1B1: 470.100 to 614.375 DSSM-B1C1 (US): 537.600 to 607.950; 614.050 to 615.950; 653.050 to 662.950 DSSM/E01-B1C1: 537.600 to 691.175 DSSM/E07-941: 941.600 to 951.900; 953.100 to 956.150; 956.550 to 959.750 |
|---|---|
| Frequency Selection Steps | 25kHz |
| RF Power Output | Selectable: 10/25/50mW (D2 mode) or 4mW (HDM mode) 20mW max for North American B1C1 in 614.050 to 615.950 and 653.050 to 662.950 |
| Encryption | AES-256-CTR (FIPS 197, FIPS 140-2) |
| Compatibility Modes | HDM or D2 |
| Frequency Stability | ±0.002% |
| Spurious Radiation | Compliant with ETSI EN 300 422-1 |
| Equivalent Input Noise | −120dBV (A-weighted) |
| Input Level | Nominal 2mV to 300mV before limiting; >1V max with limiting |
| Input Impedance | Mic: 300 or 4.5kΩ (selectable); Line: 900Ω; Instrument: 1MΩ |
| Input Limiter | DSP-controlled dual-envelope “soft” limiter with greater limiter; >30dB range |
| Gain Control Range | −7 to +44dB; 1dB steps |
| Modulation Indicators | Dual bi-colour LEDs at −20/−10/0/+10dB ref full modulation |
| Audio Performance | Frequency response 35 to 20kHz (D2), 35 to 15kHz (HDM) |
| Low-Frequency Roll-Off | Selectable: 35/50/70/100/120/150Hz |
| THD | 0.2% (typical) |
| Controls & UI | Front panel membrane switches with OLED interface |
| Audio Input Jack | Locking sub-miniature 3-pin |
| Battery | Lithium-ion 3.6V 1000mAh LB-50 pack (included)
Battery Life: |
| Weight | 100g including battery (3.5oz) |
| Dimensions (Housing) | 66—49—17mm |
| Emission Designator | 110KG1E (HD mode); 170KG1E (D2 mode) |
| Charging | Dock chargeable with optional CHSDSSM; modules daisy-chain up to 16 units with DCR5/9AU PSU |
| Included Hardware | Repositionable wire belt clip (antenna up or down) |







